SITEMAP   ::   FAQS   ::   HELP
TELEPHONE : (506) - 726 - 8805


Treating the entire unit result in reduction, friction, wear and achieve maximum overall efficiency and protection

Tweet this
Tweet this


MoreMPG™ Metal Treatment Dosage

Note: Treating the entire unit will result in reduction of friction and wear and help to achieve maximum overall efficiency and protection.

Gas Engines: 4 and 6 Cylinder 2 oz. (59ml)   *Required

Gas Engines: 8 and 10 Cylinder 4 oz. (118ml)   *Required

Automatic Transmission: Dosage 2 oz. (59ml)  *Required

Manual Transmission: Dosage of 4 oz. (118ml) *Required

Transfer Case: Dosage of 2 oz. (59ml) *Required

Each Differentials: Dosage of 4 oz. (118ml) *Required

How to treat an engine with MoreMPG™

1- Have engine warmed up, ensure vehicle is in park or neutral with parking brake on and wheels blocked.

2- If possible add product with the engine running. If blow by is present shut engine off, add MoreMPG™ and immediately start engine, bring your engines rpm's up to 1500-2000 RPM and hold for 30-60 seconds. This procedure will ensure that MoreMPG™ covers the entire engine as MoreMPG™ does not mix with your oil ! The oil is only a carrier of the product as the oil is circulated MoreMPG™ will cover all metal components. Immediatly run engine for no less than 30 minutes, Preferred method is to drive the vehicle for approximately 50 kilometers. For best results. (Do Not Shut Engine Off) for at Least 30 Minutes after adding MoreMPG™

Known issues with use of MoreMPG™ in Gas Enginetreatment.

MoreMPG™:is intended to help your engine by impregnating a ceramic seal into the metal components. This provides a near perfect cylinder seal which increases compression. If you maintain your car as prescribed by the manufacturere you should have no problems. If after treatment you notice a change for the better, then after about 150 kilometers you notice a slight misfire at idle,or poor fuel mileage then chances are you have old/faulty spark plugs or wires. Changing the fuel filter will also insure proper pressure and fuel atomization in the combustion chamber.

Let me explain why.

When compression goes up it will cause more resistance and load on your ignition system parts, if they where marginal (needed replacing) prior to treatment then they may fail.


Replace spark plugs, Check plug wires for arching (replace if necesary)

Proper maintenance is a good way to protect your investment in your car or truck, and can save you hundreds of dollars in fuel costs annually.